🇫🇷 Le pistolet et le canon avec filetage ne sont pas inclus. 🇬🇧 Pistol and threaded barrel not included.
Original and exclusive sound reducer, designed for HDR50 and HDP50 revolvers fitted with an M15x1 threaded barrel. Its slim 33 mm diameter leaves the revolver's sight completely clear, while damping the noise of the gas at the barrel's exit. The compact version of our M15x1 range.
If you don't have the M15x1 threaded barrel, you can buy it in the shop by clicking here.
At 33 mm in diameter and 140 mm long, this model is the most discreet in our M15x1 range. Its reduced bulk leaves the sight entirely clear: you equip your revolver without sacrificing your aim, and the gun stays easy to handle, with no excessive overhang at the muzzle. It dampens the exhaust gas noise and clearly transforms the look of your HDR50 or HDP50.
An honest note: on all revolvers, most of the noise comes from the cylinder. This reducer therefore acts on the exhaust gas only, for a real but partial reduction. If you're after maximum noise reduction, our Ø40 mm version in 175 mm offers a greater internal volume.
Our suppressors are 3D printed in a high-grade technical filament, selected for its mechanical and thermal resistance (85-95 °C). With five years of experience in additive manufacturing, we have rigorously tested this material: excellent mechanical strength, optimal layer bonding and a professional finish. An Invent3D creation, produced in our French workshop, designed from the outset for category D air-powered guns.
Always shoot with a properly filled CO2 cartridge. Insufficient pressure lowers the projectile's speed and stability, and it may then drift from the barrel's axis and strike the inside of the reducer.
Take extra care if you shoot heavier projectiles: the heavier a projectile, the more energy it needs to be propelled correctly. A cartridge at the end of its life no longer delivers that energy. The habit to adopt: change cartridge as soon as you feel the power dropping, rather than finishing the last balls at low pressure.
Your moderator's thread has been carefully checked using a precision tap to guarantee optimal quality.
Always screw it on straight, without forcing: a correctly aligned moderator screws on with no resistance. If it resists, stop — that's a sign of poor concentricity. Unscrew it, realign the moderator with the barrel's axis and start again.
To make installation easier, apply a little oil to the thread.
This product can be sanded and painted for a cleaner look:
Please check carefully that your barrel is threaded in M15x1 before ordering. If you don't have it, it's available as an option in the shop. If in doubt, our customer service is available to help.
Made in France using 3D printing, this sound reducer is an Invent3D creation. Design and production controlled in-house, for an accessory dedicated to your HDR50 or HDP50. 🇫🇷
Your sound reducer is shipped quickly and carefully packaged. 📦
🔹 Authorised use only on category D air guns (PCP, CO2, pellet rifles) under 20 joules, in accordance with French law.
🛑 Use on a firearm is strictly prohibited.
The buyer is solely responsible for the use of the product and must ensure its compliance with the legislation in force.
Data sheet
