Top contributeurs
-
#1M
-
#2G
-
#3D
-
#4F
-
#5N
Snowpeak T-REX
Snowpeak T-Rex Accessories — Moderators, Adapters and Magazines
Range of 3D-printed accessories for the Snowpeak T-Rex PCP rifle: original moderator replacement, adapters for universal suppressors, thread protectors and magazines. Everything to optimize and customize your T-Rex.
Our T-Rex range
- Suppressor + adapter pack: complete solution to replace the original moderator
- M12 to 1/2 UNF adapter: to mount a universal suppressor
- Thread protector: protects the thread after removal
- Barrel cap: clean finish without a moderator
- Single-shot magazine: a handy accessory for the T-Rex
Why this range dedicated to the Snowpeak T-Rex
This range brings together everything you need to optimize and customize your Snowpeak T-Rex PCP rifle. You can replace the original moderator with a dedicated model, mount a universal suppressor using the M12 to 1/2 UNF adapter, protect your thread after removal with a cap, or add a single-shot magazine. Each part meets a specific T-Rex need, with no need to look for compatibility elsewhere.
The accessories in this range are designed and 3D printed in France, with a careful, artisanal approach. The moderators are designed and made specifically for category D air-powered guns: unlike a firearm moderator, whose use on these guns is prohibited, the Invent3D moderator is designed for this purpose from the outset. A mark of compliance as much as a sign of quality.
Compatibility
- Snowpeak T-Rex PCP rifle
- M12 to 1/2 UNF adapter for universal suppressors
Please check which model each accessory fits before ordering. If you have any doubt about compatibility with your setup, our customer service is available to help.
Made in France
Made in France using 3D printing, these accessories are part of our range dedicated to the Snowpeak T-Rex. Designed and produced in-house by Invent3D, to optimize your PCP rifle. 🇫🇷
Shipping
Your accessories are shipped quickly and carefully packaged. 📦
