Long barrel for HDR - 12 cm

LAUNCH OFFER: €39.90

Boost your accuracy and power with an internal diameter of 12.6 mm, compared to the original 12.7 mm.

New exclusive on Invent3d! Optimized long barrel for improved precision and increased power.

Compatible with all HDR50 and HDR50L models.
Easily fits into the X-Tender (sold separately).
Works with all slugs and most rubber balls.

Installation Instructions: (Spring not included; reuse the original spring)

1. Remove all screws from the HDR50.
2. Note the orientation of the spring on the barrel (this is critical).
3. Remove the barrel and spring.
4. Place the spring onto your new barrel.
5. Oil all internal parts of your HDR50.
6. Reassemble and check that the cylinder turns freely without a CO2 cartridge.

Installing this barrel will void your warranty. Invent3d is not responsible for improper use or installation of the product.

🇫🇷 100% Made in France 🇫🇷 in aluminum with a chrome finish.

Tested and compatible with:

• Invent3d slugs (all models)
• Pepper balls
• Devastator rounds

Dimensions:

• Total length: 230 mm (+/- 5 mm)
• Length extending from revolver: 120 mm (+/- 5 mm)
• Internal diameter: 12.6 mm (for improved slug projection)