Removes sparklet effortlessly. Orange colour.
Exclusive to Invent3D.
3D-printed sparklet remover tool to effortlessly unscrew and remove the CO2 capsule (sparklet) on the T4E HDR50, HDP50, HDS68 and NXG PS-100 launchers. Orange color.
Designed and manufactured in France by Invent3D, this accessory makes handling the CO2 capsule easier, especially when it is tight or hard to reach by hand. It offers a better grip and a better tightening torque for clean and quick disassembly.
The sparklet capsule can be a pain to unscrew or remove with bare hands, especially after several shots or in cold weather. This sparklet remover positions itself on the capsule to give you a firm grip and better leverage. Result: you remove the capsule without forcing, without slipping and without tiring your fingers.
This tool is designed for the following models (1st Gen):
It may be suitable for other launchers using the same type of sparklet capsule, but these uses have not been tested by Invent3D.
Position the tool on the sparklet capsule, then apply rotation to unscrew or rescrew. Thanks to the reinforced grip, the applied torque is more regular and handling becomes simple, even with one hand.
Fast and careful shipping from France. 📦
3D-printed in France, this sparklet remover is a small practical accessory that saves time with each capsule change. The orange color makes it easy to spot in the bag or on the shooting table. A simple and clever complement to maintain and use your T4E equipment with complete peace of mind.
Data sheet
Removes sparklet effortlessly. Orange colour.
Exclusive to Invent3D.
