Invent3D Suppressor + Adapter Kit for Snowpeak T-REX – Ø40 mm Mamba

Mamba Ø40 mm Suppressor + Barrel Cap Adapter Pack for Snowpeak T-Rex

Complete pack to improve the sound performance of your Snowpeak T-Rex, whose built-in suppressor remains limited, without spoiling the rifle's looks. It includes an adapter with an integrated barrel cap that screws directly onto the rifle, and a Mamba Ø40 mm suppressor designed exclusively for this adapter.

Specifications

• Pack: adapter with integrated barrel cap + Mamba Ø40 mm suppressor
• Moderator: 40 mm diameter × 175 mm length
• Total length once fitted: 115 mm
• Compatible with all calibers and all power levels of the T-Rex
• Not compatible with the M25 model
• French-made

Why choose this pack

If you're disappointed by the limited efficiency of your Snowpeak T-Rex's built-in suppressor, this pack has been specially designed to improve performance without spoiling the rifle's looks. The adapter with integrated barrel cap screws directly onto the rifle, and the Mamba Ø40 mm suppressor was designed exclusively for this adapter: together they form a coherent, high-performing solution, compatible with all calibers and all power levels.

Made in France using high-quality 3D printing, this pack has a matte to semi-gloss finish. The surface can be sanded and painted (primer recommended) for full customization, with a careful, artisanal approach to manufacturing.

Installation

• Remove the original suppressor from your rifle (tutorial available here).
• Insert the barrel cap until it reaches the height of the seal.
• Gently screw on the barrel cap.
• Tip: start by screwing on the suppressor to make the final tightening of the barrel cap easier.
• Do not tighten the suppressor: you must not force it, it's unnecessary and risks breakage.

⚠️ Warning: this operation voids the manufacturer's warranty. Invent3D cannot be held liable for any damage. If you are not comfortable with this procedure, it is best to keep the original suppressor. No technical support will be provided for this step.

Replacement seal

If you need to replace the seal on the barrel cap, it is the 22/18 Tore 2 model, available in the "Seals" section by clicking here.

Compatibility

• All calibers of the Snowpeak T-Rex
• All power levels
• Not compatible with the M25 model

Please check that your rifle matches (excluding the M25 model) before ordering. If you have any doubt about compatibility with your setup,