Adapter to install a UNF 1/2 silencer on the Armada, Marauder, Fortitude and Akela. For 4.5 and 5.5 only.
3D-printed threaded adapter to convert from the original thread to a 1/2 UNF thread, compatible with the Armada, Marauder, Akela and Fortitude PCP rifles. Compatible with 4.5 mm and 5.5 mm projectiles.
This adapter has been tested on the following models:
The adapter screws onto the Kral side onto the original thread of the rifle, then receives on the 1/2 UNF side the accessory of your choice (moderator, flash hider or other 1/2 UNF standard accessory). Do not overtighten the UNF threaded part: moderate tightening is enough to hold the accessory and preserves the integrity of the printed thread. The 6.5 mm internal diameter leaves free passage for 4.5 mm, 5.5 mm and 6.35 mm projectiles.
Designed and manufactured in France by 3D printing, this adapter allows you to open up your Armada, Marauder, Akela or Fortitude PCP rifle to the entire ecosystem of 1/2 UNF standard accessories.
Rather than being limited to the original thread, you benefit from a universal mounting and upgrade your equipment easily. Its careful design and its 100% recyclable material, resistant up to 85-95 °C, make it a reliable upgrade part to customize your setup.
Adapter shipped carefully packaged. 📦
Adapter to install a UNF 1/2 silencer on the Armada, Marauder, Fortitude and Akela. For 4.5 and 5.5 only.
