Adapter for installing a 1/2 UNF silencer on the Kral Armour (and other models)...
Compatible with Kral Puncher Armour, Armada, Marauder, Fortitude, and Akela.
3D-printed threaded adapter to convert from the original Kral thread to a 1/2 UNF thread, compatible with Armada, Marauder and Fortitude PCP rifles. Internal diameter of 6.5 mm, compatible with 4.5 mm, 5.5 mm and 6.35 mm projectiles.
This adapter has been tested on the following models:
It is also advertised as compatible with Armada, Marauder and Fortitude rifles. On any other model not listed, compatibility has not been tested and must be verified before mounting.
The adapter screws onto the Kral side on the rifle's original thread, then receives on the 1/2 UNF side the accessory of your choice (moderator, flash hider or other accessory in the 1/2 UNF standard). Do not over-tighten the UNF threaded part: moderate tightening is enough to hold the accessory and preserves the integrity of the printed thread. The 6.5 mm internal diameter leaves a clear passage for 4.5 mm, 5.5 mm and 6.35 mm projectiles.
Designed and manufactured in France using 3D printing, this adapter allows you to open your Kral, Armada, Marauder or Fortitude PCP rifle to the entire ecosystem of accessories in the 1/2 UNF standard. Rather than being limited to the original thread, you benefit from a universal mounting and upgrade your equipment easily. Its careful design and its 100% recyclable material, resistant up to 85-95 °C, make it a reliable upgrade part to customize your configuration.
Adapter shipped carefully packaged.
Adapter for installing a 1/2 UNF silencer on the Kral Armour (and other models)...
Compatible with Kral Puncher Armour, Armada, Marauder, Fortitude, and Akela.
