Carbon Flame Cover 90 mm - Kral Armor Punch

Flash hider 90 mm 1/2 UNF thread — Black

3D-printed flash hider for PCP rifle, 90 mm length and standard 1/2 UNF thread, compatible with a wide range of models. An accessory designed by Invent3D, made to dress up the barrel outlet while providing effective protection.

Technical specifications

• Diameter: 26 mm
• Length: 90 mm (measured from the barrel outlet)
• Thread: 1/2 UNF (standard)
• Color: black
• Construction: reinforced 3D printing for increased durability and optimal resistance
• Made in France

Why this flash hider

Its 1/2 UNF thread, which is one of the most widespread standards on PCP rifles, allows it to fit a large number of models without an additional adapter. The reinforced 3D-printed design ensures good durability over time, and its 90 mm profile adds a distinctive aesthetic touch to the barrel outlet. It is an ideal accessory to personalize and develop the look of your equipment, while protecting the end of the barrel.

Compatibility

This flash hider has been tested on many popular models. It is compatible with the following rifles:

• Aselkon: MX5, MX6 Régulateur Jet Black, MX8, Sniper MX9, MX10, MX10S, RX6 Ravello
• Benjamin: Armada
• Beretta: Cx4 Storm
• BSA: PCP Scorpion, Brigadier
• Crosman: Prospect
• FX Airguns: Wildcat MKIII *
• Hatsan: AT44W-10 (except QE), AT44S-10 (except QE), AT44-10-Tact (except QE), BT 65, Flashpup S, Factor, Galatian II, NovaStar
• Kral: Breaker Syntetic, NP-01, NP-02, Puncher Ekinoks (≤ 40 joules), Puncher Knight, Puncher Jumbo Dazzle, Puncher S, Puncher Wood
• Legends: Cowboy Rifle Renegade
• Reximex: Pretensis Daystar, Throne Gen 2, Zone, Lieva
• Snowpeak: M25, Regulated, AP 1000
• Stoeger: Xm1 Bullpup
• Trimex Arms: ELF-S Bullpup, Tacto-S
• Umarex: 850 M2, Iconix *
• Walther: 1250 Dominator, Reign M2, Reign M2 L, Rotex RM8, Rotex RM8 Varmint, Rotex RM8 Varmint UC

Note: although this product has been tested on the models listed, it is strongly recommended to check the thread compatibility with your rifle before placing an order.

Installation

Installation is done directly by screwing onto the 1/2 UNF thread at the barrel outlet. Simply check that your rifle does have this standard thread before installation.

Delivery

Flash hider designed and manufactured in France by Invent3D, shipped carefully packaged. 📦