Flash Hider 77mm UNF 1/2 - Black

Flash hider 77 mm thread 1/2 UNF - Black

3D-printed flash hider for PCP rifles, standard 1/2 UNF thread, length 77 mm. An accessory that combines aesthetics and protection at the muzzle, compatible with a wide range of models.

Features

• Thread: 1/2 UNF (very widespread standard on PCPs)
• Diameter: 26 mm
• Length: 77 mm (measured from the muzzle)
• Color: black
• Construction: reinforced 3D printing for increased durability and optimal resistance
• Exclusive Invent3D design, made in France

The 1/2 UNF thread is one of the most common standards on the PCP market: it allows direct mounting on many rifles without an additional adapter. The reinforced 3D-printed construction offers good durability over time, for an accessory that personalizes the look of the rifle while protecting the muzzle.

Compatibility

This flash hider has been tested on numerous popular models. It is compatible with the following rifles:

• Aselkon: MX5, MX6 Régulateur Jet Black, MX8, Sniper MX9, MX10, MX10S, RX6 Ravello
• Benjamin: Armada
• Beretta: Cx4 Storm
• BSA: PCP Scorpion, Brigadier
• Crosman: Prospect
• FX Airguns: Wildcat MKIII *
• Hatsan: AT44W-10 (except QE), AT44S-10 (except QE), AT44-10-Tact (except QE), BT 65, Flashpup S, Factor, Galatian II, NovaStar
• Kral: Breaker Syntetic, NP-01, NP-02, Puncher Ekinoks (≤ 40 joules), Puncher Knight, Puncher Jumbo Dazzle, Puncher S, Puncher Wood
• Legends: Cowboy Rifle Renegade
• Reximex: Pretensis Daystar, Throne Gen 2, Zone, Lieva
• Snowpeak: M25, Regulated, AP 1000
• Stoeger: Xm1 Bullpup
• Trimex Arms: ELF-S Bullpup, Tacto-S
• Umarex: 850 M2, Iconix *
• Walther: 1250 Dominator, Reign M2, Reign M2 L, Rotex RM8, Rotex RM8 Varmint, Rotex RM8 Varmint UC

Although this product has been tested on the models listed above, it is strongly recommended to check the thread and compatibility with your rifle before placing an order.

Mounting

Installation is direct on any barrel with a 1/2 UNF thread: simply screw the flash hider onto the muzzle. No specific tool is needed for the compatible models listed.

Why choose this Invent3D flash hider

Designed and manufactured in France by 3D printing, this flash hider is an Invent3D exclusive designed for PCP rifle enthusiasts who like to personalize and upgrade their equipment. Its standard 1/2 UNF thread ensures wide compatibility, and its reinforced construction guarantees good resistance in use.

Delivery

Fast and careful shipping from France 📦.